Oshare
Distinguished Member
- Joined
- May 3, 2017
- Messages
- 1,444
- Reaction score
- 6,792
@friendlygoz and @Oshare
Would you trust using eyelet/grommet pliers on a similar job? I might visit the craft store today...
I don't have any first hand experience with the grommet pliers, but I did come across comments that they are finicky and don't always go in straight. Because of that, I went with the punch and anvil block approach, and just used a hammer to tap them in. Glad I did. It was actually a lot easier than I was expecting.