I like that fabric. The jacket looks good from the front, though I'm not sure how you ended-up with sleeves so long on an MTM garment. Looks like they need to be shortened at least half an inch (the right one even more, perhaps) which might result in the buttons being too close to the end, assuming you opted for functional cuffs. Back of the jacket and trousers look very messy. Don't know about the trousers, but the jacket can be cleaned-up with some tailoring and definitely on any future MTM orders.
I got fitted at the popup store in NYC and the sleeves were supposed to be shortened but I realized after I received the suit that this was not in the confirmation email with the adjustments they sent me and these sleeves measure the standard length for a 40R. Anyways, there is 1.5" of fabric below the end of the last button (functional), so I believe while not optimal they can be shortened .5" or .75" at absolute most without throwing off the balance. I don't think I'll be able to tell how the pants really drape until I have them hemmed, so I will try to get pics after I send them to my tailor so I can make adjustments for future orders.
I'm guessing the back should clean up a bit when the waist is taken in since there is a lot of extra fabric through the waist (my upper waist measurement is only about 29.5" and this is the standard 40R shoulder) which when paired with my posture and causes it all to bunch in the back yet still look relatively OK from the front. Any suggestions on how else the back could be cleaned up a bit for future orders?