New Posts  All Forums:

Posts by OTCtailor

This can be done much more successfully than if it had normal flapped pockets. Maybe a relatively expensive fix altogether but the end result if done correctly will be just fine
To some degree, this is accurate. If you have sloping shoulders And you're wearing a soft shoulder jacket, they may fall a little too much. There are limits to how sloped they can slope the shoulders before it becomes a matter of adding padding. My clients that have extreme shoulder slope get an extremely sloped jacket and at least a half inch of padding. Sometimes asking for that smaller halfback remedies the issue but this is not an easy thing to nail down with mtm much...
He may have let the stride out too much? Check the top of the inseam on the inside and look to see if it was altered there. If it looks like the inseam at the top has been let out in that there is no more fabric there to let it out, check the stitching to see if its been altered. When that area is being messed with, its not hard to accidently alter the run of the crotch if you're not careful.
No. In case you haven't noticed, the menswear industry is experiencing a nice little growth spurt and those of us who operate a tailoring business are, well, a little busy.We try to answer as fast as possible.
Have them insert a pad to see how that affects the wrinkles. Basically, the back part of the shoulder needs to be more sloped.If it's MTM...a little more slope, maybe a smaller point to point, less half back, higher armhole, consider the pitch of your shoulders and if the MTM house can adjust for that.
I wouldn't measure off the pants. Have someone measure your true waist and seat. You can keep the rise from these (outseam minus inseam) but they need to have less rise in the back, and be adjusted for flat seat and forward hips
Open the seam at the thigh? That could mean a variety of things...The rear fork could be released and that may help things. In general, you can do this slim fit if you have double darts over the back pockets, and extra rear fork quantity. it's for prominent seat. Less rise in the front will also help balance the trouser a bit.
The seat curve needs to be hollowed more or taken in at the lower portion of where it curves. That will take out the wedgie wrinkle. Also, the rear fork must be let out to give space to the seat and crotch.
The shoulders are not cut sloped enough for your shoulders. Have a tailor insert a pad while you're wearing the jacket and see the difference. That may also change the sleeve length a little if you decide to do that. The vents may not be wide enough over the seat. The pants need to be adjusted in the seat and back rise to help with the collapsing cloth.
Try darts in the shirt. Have the seller check the shoulder slope. Less rise in the back of the trouser. Seat curve needs to be more hollow on that pair.
New Posts  All Forums: